|
Directions

Step 1: Cut two 8-1/2 x 11" sheets of colored cardstock into sections and label as shown above.
>>view picture
Step 2: With gel markers, draw the different dragon body parts onto the reverse side of each labeled piece of colored cardstock.
>>view picture
Step 3: Cut out each body part with scissors. With the hole punch, make holes into each joint of the dragon parts. You will need approximately ten eyelet sets or brads to combine joints. If using eyelets, set them into place using the setter tool.
>>view picture
General Materials

• Scissors
• Pen
• 1/8" Hole Punch
Project Materials

|